Set at 150 ft lbs, I think I read that online a few different places. But I would check the manuals or online for yourself. Now I had an issue with this, and I'm not sure how to address it. At some point, you can't turn it anymore without the ball joint turning as well. That's why you see the nut type end on the ball joint, to hold it in place. However, if you have to hold that, then how are you supposed to torque it, because you can't put a torque wrench over the top of another ratchet holding the stud. So anyway, just a little something to think about. My experiences. I got it as tight as I could get it, and have been checking it since and it's not moved. Use your own common sense.
Loading...